Engine Types

W Engines Explained: How VW's W8, W12 and W16 Are Built

What a W engine is and how Volkswagen built its W8, W12 and W16 by joining narrow-angle VR banks on one crankshaft, plus the trade-offs of the layout.

On this page
  1. What a W engine is
  2. Two kinds of W engine
  3. Start with the VR6
  4. How the W8 is built
  5. How the W12 is built
  6. How the W16 is built
  7. VW’s W engines compared
  8. Why Volkswagen built W engines
  9. Drawbacks of W engines
  10. The end of the W engine
  11. W vs V vs VR

What a W engine is

A W engine is a piston engine with more than two banks of cylinders sharing a single crankshaft, arranged so that, seen from the front, the banks roughly form the letter W. The aim is to fit a large number of cylinders into an engine that is shorter than an equivalent V engine.

Today the term is most closely associated with Volkswagen Group, which built W8, W12 and W16 engines for cars ranging from the Passat to the Bugatti Veyron. For an overview of how W engines compare with inline, V and flat layouts, see our guide to the types of car engines.

Two kinds of W engine

The name has been used for two different designs:

  • Three-bank W engines. Three banks of cylinders are spread out in a fan around one crankshaft, usually with a vertical centre bank and one bank on each side. These are also called broad-arrow or fan engines. The best-known example is the Napier Lion, a 12-cylinder aircraft engine of the 1920s with three banks of four. A few early motorcycles and aircraft used small three-cylinder W3 engines.
  • Four-bank W engines. Four banks are arranged as two narrow V pairs, which are then set at a wider angle to each other on a common crankshaft. Volkswagen’s W8, W12 and W16 use this layout. It is sometimes called a double-V or, in VW’s case, a double-VR engine.

The rest of this article covers the Volkswagen designs.

Start with the VR6

To understand Volkswagen’s W engines, start with the VR6. It is a V6 with an unusually narrow angle between its banks, around 15 degrees in the original version and a little less in some later ones.

At that narrow angle, the two banks are so close together that the cylinders are staggered in a zigzag pattern within a single block, and one cylinder head covers all six cylinders. In effect, it is a compromise between an inline-six and a V6:

  • Shorter than an inline-six, so it fits sideways in front-wheel-drive cars such as the Golf and Passat
  • Narrower than a conventional V6, with only one cylinder head

Each pair of narrow-angle banks in a W engine is essentially a VR engine.

How the W8 is built

The W8 takes two narrow-angle four-cylinder banks, each like half of a VR8 or a “VR4,” and sets them on a common crankshaft at a wider angle of about 72 degrees. The result is an eight-cylinder engine that is shorter than a typical V8.

Volkswagen offered a 4.0-litre W8 in the Passat in the early 2000s, at the top of the range alongside four-wheel drive. It was a smooth, compact way to fit eight cylinders into a mid-size car, but sales were modest and it was dropped after a few years. Like some other eight-cylinder designs with a flat-plane-style crankshaft, it used balance shafts to control vibration. For more on how crankshaft layout affects eight-cylinder engines, see our article on flat-plane vs cross-plane crank V8s.

How the W12 is built

The W12 is the most widely used of the Volkswagen W engines. It is essentially two VR6 engines joined at the crankshaft, with the two VR6 halves set at about 72 degrees to each other. Each VR6 half has its own cylinder head, so the engine has two heads covering four banks of three cylinders.

The result is a 12-cylinder engine not much longer than a VR6 and comparable in size to many V8s. That compactness allowed Volkswagen Group to fit 12 cylinders into cars that would struggle to package a long V12.

The W12, mostly in 6.0-litre form and later with twin turbochargers, was used in:

  • The Volkswagen Phaeton luxury sedan
  • Some versions of the Volkswagen Touareg
  • The Audi A8
  • Bentley’s Continental GT, Flying Spur and Bentayga

How the W16 is built

The W16 follows the same idea on a larger scale. It combines two narrow-angle VR8 engines, each with two banks of four cylinders, on a common crankshaft, with the two VR8 halves set at 90 degrees to each other.

Bugatti used an 8.0-litre W16 with four turbochargers in the Veyron, launched in the mid-2000s with 1,001 metric horsepower, and in its successor, the Chiron, in more powerful form. Packing 16 cylinders into a block short enough to sit behind the cabin of a mid-engined car would have been extremely difficult with a conventional V16, which is a large part of why the W layout was chosen.

VW’s W engines compared

W8 W12 W16
Built from Two narrow-angle four-cylinder banks Two VR6 halves Two VR8 halves
Angle between halves About 72 degrees About 72 degrees 90 degrees
Typical displacement 4.0 litres Mostly 6.0 litres 8.0 litres
Aspiration Naturally aspirated Naturally aspirated and twin-turbo versions Quad-turbo
Notable cars VW Passat W8 VW Phaeton, Audi A8, Bentley Continental GT Bugatti Veyron and Chiron

Why Volkswagen built W engines

  • Compactness. The main attraction was packing many cylinders into a short engine. A W12 is much shorter than a V12, and a W16 is far shorter than a V16.
  • Shared engineering. Building on the existing VR engine family let Volkswagen reuse ideas and parts.
  • Fitting existing platforms. A compact 12-cylinder engine could be fitted into platforms such as the Audi A8 and the Phaeton that were not designed around a long V12.
  • Prestige. Offering eight, twelve and sixteen cylinders gave Volkswagen Group’s luxury and performance brands headline engines.

Drawbacks of W engines

  • Complexity. A W engine has many cylinders packed tightly together, with complex cylinder heads, timing drives and intake and exhaust plumbing.
  • Heat. Packing so many cylinders and, in many versions, turbochargers into a small space creates a lot of heat to manage.
  • Maintenance access. With the engine filling the bay, some jobs that are simple on other engines can require major disassembly, which raises repair costs.
  • Cost. These engines were expensive to make and were used in relatively small numbers.
  • Weight. Compact is not the same as light; a W12 or W16 is still a heavy engine.

The end of the W engine

Tighter emissions rules and the shift toward electrification have brought the W era to a close. The W8 had already gone by the mid-2000s, and Volkswagen and Audi dropped the W12 from their own models over the following years. Bentley ended W12 production in 2024, moving to plug-in hybrid V8 powertrains.

Bugatti also retired the W16 after the Chiron and its derivatives. Its new hypercar, the Tourbillon, uses a naturally aspirated V16 combined with electric motors, a sign that the compactness argument for the W layout matters less when hybrid systems can supply much of the extra power.

W vs V vs VR

V engine VR engine W engine (VW type)
Banks Two, usually 60 to 90 degrees apart Two, very narrow angle Four, in two narrow pairs
Cylinder heads Two One Two
Length Shorter than inline Shorter than inline, close to V Very short for its cylinder count
Complexity Moderate Moderate High
Examples Most V6, V8 and V12 engines VW VR6 VW W8, W12, W16

W engines are not the only way designers have tried to pack many cylinders into a compact engine. Aircraft engineers used H and X layouts for 24-cylinder engines, as our answer to whether there is a V24 engine explains. And for a layout that wins on simplicity rather than compactness, see our guide to inline-6 engines.

The complete guide to engine types

Types of Car Engines: Layouts, Cylinder Arrangements and Placement
Read the guide

Keep exploring

Guides from other topics

All topics →