The short answer: air, fuel and spark
A petrol engine needs three things to run:
- Air, which supplies the oxygen fuel needs to burn
- Fuel, which supplies the energy
- Spark, which ignites the mixture at the right moment
Take away any one of them and the engine stops or won’t start. Many mechanics add a fourth requirement, compression, and stress that all of them have to arrive at the right time. Diesel engines are the main exception to the “spark” part, as explained below.
Why these three? The fire triangle inside a cylinder
Any fire needs fuel, oxygen and heat. That’s the “fire triangle” taught in fire safety. An engine is just a carefully controlled fire inside a sealed cylinder:
- Fuel is the petrol (or diesel, or gas).
- Oxygen comes from the air the engine draws in.
- Heat to start the burn comes from the spark plug (or from compression in a diesel).
The engine’s job is to bring these together in the right proportions, in a small sealed space, many times a second. The pressure from that controlled burn pushes the piston. The full process is described in how a car engine works.
Air
Air enters through the air filter, passes the throttle and flows through the intake manifold into each cylinder during the intake stroke. Fuel can’t burn without enough oxygen. For petrol, the chemically ideal mixture is roughly 14.7 parts air to 1 part fuel by mass.
Things that can starve an engine of air include a badly clogged air filter, a blocked intake, or a fault with the throttle or its control. More often, though, air problems show up as poor running rather than a total no-start. That’s because a faulty or leaking sensor or hose upsets the air-fuel balance.
Fuel
The fuel system stores petrol in the tank, pumps it forward and meters it into the engine through injectors (or, on older engines, a carburettor). The engine computer decides how much to inject based on the amount of air coming in.
Fuel problems that stop an engine include:
- An empty tank, or a faulty fuel gauge
- A failed fuel pump or blown pump fuse or relay
- A clogged fuel filter
- Faulty injectors or injector wiring
- Stale or contaminated fuel, especially in equipment that has sat unused for months
Spark
In a petrol engine, the ignition system creates a high-voltage spark across the spark plug gap near the end of the compression stroke. That spark starts the flame that burns through the mixture. Modern cars usually have one ignition coil per cylinder, controlled by the engine computer.
Common spark problems include worn or fouled spark plugs, a failed ignition coil, damaged leads or connectors, or a fault with the crankshaft position sensor. The engine computer needs that sensor’s signal to know when to fire.
The fourth factor: compression
Air, fuel and spark aren’t enough on their own if the cylinder can’t hold pressure. Each piston has to compress the mixture on its upstroke so it burns quickly and forcefully. If compression leaks away, the cylinder produces little or no power. Leaks can happen past worn piston rings, a burnt or bent valve, or a failed head gasket.
Low compression in one cylinder usually causes a misfire. Low compression in all cylinders, for example after a timing belt failure in some engines, can stop the engine from running at all. A compression test measures this directly. The compression stroke’s role is covered in the four-stroke Otto cycle.
And the fifth: timing
Everything above has to happen at the right moment. The intake valve must open while the piston draws air in, the fuel must be there, and the spark must fire just before the piston reaches the top of its compression stroke. If the timing belt or chain has jumped or broken, the valves are out of step with the pistons. The engine may then crank but never start, even if air, fuel and spark are all present.
What about diesel engines?
Diesels don’t have spark plugs. They compress air alone, to a much higher compression ratio than a petrol engine. That heats the air enough that diesel fuel ignites on its own when it’s injected. For a diesel, the three essentials are better described as air, fuel and heat from compression. This makes compression even more critical. Glow plugs help some diesels start from cold by adding heat to the combustion chamber.
Using air, fuel and spark to diagnose a no-start
When an engine cranks but won’t start, mechanics often work through these essentials in turn. The table below is a rough guide, not a full diagnosis:
| Missing ingredient | Possible signs | Common causes |
|---|---|---|
| Fuel | No fuel pump hum when the ignition is switched on (on many cars); dry spark plugs | Empty tank, pump or fuse/relay failure, blocked filter |
| Spark | Fuel smell but no firing; wet spark plugs | Failed coil, worn plugs, crankshaft sensor fault |
| Air | Rare as a total no-start; more often rough running or stalling | Blocked intake, throttle fault, severe filter blockage |
| Compression | Even, fast cranking that sounds “too easy”; no firing at all | Broken timing belt, valve damage, head gasket failure |
A few cautions:
- Don’t keep cranking for long periods. It drains the battery and can overheat the starter.
- Don’t try to test for spark by holding a lead near metal, or spray flammable starting aids into an engine you’re unfamiliar with. Ignition systems carry high voltage, and fuel vapour is a fire risk.
- If a check engine light is on, reading the fault codes is often the quickest way to narrow the problem down.
If the engine won’t crank at all, the issue usually lies elsewhere: a flat battery, a starter fault, or an immobiliser problem, rather than with air, fuel or spark.