Engine Reliability

BMW Engines to Avoid: N47, N63 and Other Problem Motors

The BMW engines to avoid, from the N47 diesel's rear timing chain to the hot-vee N63, N54 fuel pumps and N20 chain guides, plus the BMW engines worth buying.

On this page
  1. N47 2.0L Diesel: The Timing Chain at the Back
  2. N63 4.4L Twin-Turbo V8: The Hot-Vee Problem
  3. N62 V8
  4. N54 3.0L Twin-Turbo Inline-Six
  5. N20 and N26 2.0L Turbo Four
  6. S65 and S85 M Engines: Rod Bearings
  7. Older Engines: Nikasil M60 and Early M62 V8s
  8. Problems Common to Many BMW Engines
  9. Summary Table
  10. BMW Engines With Good Reputations
  11. How to Buy a Used BMW Safely

The BMW engines most often recommended to avoid on the used market are the N47 2.0-liter diesel (timing chain failure), the N63 4.4-liter twin-turbo V8 (heat-related oil consumption and more), the N62 V8 (valve stem seals and coolant leaks), the N54 twin-turbo inline-six (fuel pumps and injectors), the N20/N26 2.0-liter turbo four (timing chain guides), and the high-revving S65 V8 and S85 V10 M engines (rod bearings).

Many of these engines are excellent to drive, and a well-maintained example can be fine. But they’re expensive to own when things go wrong, so it pays to know what fails and why.

N47 2.0L Diesel: The Timing Chain at the Back

Found in: many four-cylinder diesel BMWs (and some Minis) from around 2007 into the mid-2010s, such as the 118d, 120d, 320d, 520d and X1/X3 18d/20d.

The N47’s big problem is its timing chain. Chains and guides on many engines, especially earlier ones, wear prematurely. A stretched chain makes a rattle or whine, and a broken chain usually wrecks the engine.

What makes it worse is where the chain is. BMW put it at the flywheel (transmission) end of the engine, so replacing it usually means removing the engine or transmission. That turns a chain job into a very large bill. BMW revised the parts during production, and the B47 that replaced the N47 is generally better regarded.

The N47 also has the usual modern-diesel issues: EGR valves and coolers, swirl flaps on some versions, and DPF clogging on cars that only make short trips.

Buying tip: listen for rattle at idle and on startup, and ask whether the chain has been replaced with updated parts.

N63 4.4L Twin-Turbo V8: The Hot-Vee Problem

Found in: the 550i, 750i, X5/X6 50i and 650i, from 2008 onward. (The S63 in M cars is a related engine.)

The N63 puts its two turbochargers inside the “V” between the cylinder banks. That “hot-vee” layout shortens the exhaust path and improves turbo response, but it packs a lot of heat into the top of the engine. Early N63s are known for:

  • High oil consumption, often linked to valve stem seals degraded by heat.
  • Timing chain stretch.
  • Fuel injector and ignition problems.
  • Cooling system and vacuum line failures, as plastic and rubber parts cook in the valley.
  • Turbo oil line and coolant leaks.

BMW issued a customer care package for many early N63 cars, updating parts and software. The revised N63TU versions are generally considered better, though still complex and costly to repair. On a used N63 car, ask which updates and recalls have been completed.

N62 V8

Found in: the 545i/550i, 645i/650i, 745i/750i and X5 4.4i/4.8i, roughly from the early-to-mid 2000s.

The naturally aspirated N62 is smoother and simpler than the N63 but has its own expensive weak spots:

  • Valve stem seals that harden and leak, causing blue smoke on startup and oil burning. Replacing them is labor-intensive.
  • Coolant leaks from the engine valley, such as from the coolant transfer pipe under the intake, which take a lot of disassembly to reach.
  • Alternator bracket gasket and valve cover leaks.

N54 3.0L Twin-Turbo Inline-Six

Found in: the 335i, 135i, 535i, Z4 sDrive35i and X6 35i, around 2006–2013.

The N54 is loved by tuners because it can make big power. Its common issues include:

  • High-pressure fuel pump (HPFP) failures, which cause long cranks, limp mode and hesitation. In the US, BMW extended warranty coverage on the HPFP, and many cars have had replacement pumps.
  • Leaking piezo fuel injectors, which have gone through several revisions.
  • Wastegate rattle on the turbochargers.
  • Intake valve carbon buildup (direct injection only).
  • Water pump failure (electric) and oil filter housing gasket leaks.

The single-turbo N55 that replaced it is generally considered more reliable.

N20 and N26 2.0L Turbo Four

Found in: the 228i, 320i/328i, 428i, 528i, X1/X3 28i and Z4 28i, from about 2011.

Earlier N20 engines are known for wear of the plastic timing chain guides. A failing guide can lead to chain whine or rattle and, at worst, chain failure and serious engine damage. BMW revised the parts, so later engines are generally better. Ask whether the timing chain guides have been replaced. The N26 is a lower-emission version sold in some US models and shares the same concerns.

S65 and S85 M Engines: Rod Bearings

S65 4.0L V8 (E9x M3, 2008–2013) and S85 5.0L V10 (E60 M5, E63 M6).

These high-revving engines are prized by enthusiasts, but they’re well known for connecting rod bearing wear, often blamed on tight bearing clearances and high-rpm use. Many owners replace the rod bearings preventively as a maintenance item. The S85 also has known throttle actuator and VANOS issues.

These aren’t “bad” engines so much as high-maintenance ones. Budget for specialist care.

Older Engines: Nikasil M60 and Early M62 V8s

Some 1990s BMW V8s (the M60 and some early M62) used a Nikasil cylinder bore coating that could be damaged by high-sulfur fuel, causing lost compression and hard starting. Many were replaced under warranty at the time. If you’re buying a 1990s 5 Series, 7 Series or 8 Series V8, ask whether the engine has been replaced or tested. We cover the wider Nikasil story in the least reliable engines of all time.

Problems Common to Many BMW Engines

Some recurring BMW repairs aren’t design flaws in one engine. They’re the cost of BMW ownership in general:

  • Plastic cooling system parts (expansion tanks, thermostat housings, pipes) that become brittle with age.
  • Electric water pumps on many six-cylinder engines.
  • Oil filter housing gasket and valve cover gasket leaks, which can drip oil onto belts or exhaust.
  • VANOS solenoids and ignition coils.

Budget for these on any older BMW, even one with a “good” engine.

Summary Table

Engine Type Typical years Main problem
N47 2.0L diesel I4 About 2007–mid 2010s Rear timing chain wear/failure
N63 (early) 4.4L TT V8 2008 onward Heat damage, oil consumption, chains, injectors
N62 4.4/4.8L V8 Early–mid 2000s Valve stem seals, valley coolant leaks
N54 3.0L TT I6 About 2006–2013 HPFP, injectors, wastegates
N20/N26 (early) 2.0L turbo I4 About 2011–2015 Timing chain guides
S65 / S85 4.0L V8 / 5.0L V10 Late 2000s–early 2010s Rod bearings, throttle actuators (S85)
M60 / early M62 V8 1990s Nikasil bore damage

BMW Engines With Good Reputations

  • M54 (2.2–3.0L inline-six, early 2000s): simple port-injected six. Cooling system and crankcase ventilation upkeep needed.
  • N52 (3.0L inline-six, naturally aspirated): generally durable apart from typical gasket and water pump items.
  • B58 (3.0L turbo inline-six, 2015 onward): widely regarded as one of BMW’s best modern engines, though coolant leaks have been reported on some.
  • M57 (3.0L diesel inline-six): one of BMW’s most respected diesels.
  • B47 and B48 (2.0L diesel and gasoline fours): generally better regarded than the engines they replaced. Some early B48s had balance shaft issues.

How to Buy a Used BMW Safely

  • Know the exact engine code. The badge (for example “328i” or “550i”) can cover very different engines from year to year.
  • Get a pre-purchase inspection from a BMW specialist who can read BMW-specific fault codes.
  • Check for completed recalls and updates, especially the N63 customer care work and N54 fuel system updates.
  • Listen at cold start for timing chain rattle (N47, N20) and look for blue smoke (N62, N63).
  • Check oil consumption and look for leaks around the oil filter housing and valve cover.
  • Budget for maintenance. BMW’s long factory oil change intervals are often shortened by enthusiasts who want the engine to last.

For how BMW’s worst engines compare with other brands’, see the least reliable engines of all time. For a German alternative, see our VW engine reliability guide.

The complete guide to engine reliability

The Least Reliable Engines of All Time
Read the guide

Keep exploring

Guides from other topics

All topics →