The Toyota engines most often named as ones to avoid are the 2AZ-FE 2.4-liter four-cylinder (oil burning and stripped head bolt threads), the 3VZ-E 3.0-liter V6 (head gaskets), the 7M-GE/7M-GTE inline-six (head gaskets), early 1ZZ-FE 1.8-liter engines (oil consumption) and early V35A-FTS twin-turbo V6 engines (a machining-debris recall).
Toyota’s overall engine reputation is strong, so “stay away” usually means “buy carefully and check the history” rather than “never buy”. Several of these problems were also covered by Toyota recalls or special warranty programs.
Toyota Engines With the Worst Reputations
2AZ-FE (2.4L Four-Cylinder)
Found in: the Camry, RAV4, Highlander, Corolla XRS, Scion tC, Solara and others, from the early 2000s to the early 2010s.
The 2AZ-FE has two well-known problems:
- Oil consumption. Many engines, especially from roughly the 2006–2011 model years, burn oil, a problem widely blamed on piston rings that clog with carbon. Toyota issued a warranty enhancement program for excessive oil consumption on certain affected vehicles.
- Head bolt threads. The head bolts thread into the aluminum block, and the threads can pull out, causing coolant leaks and head gasket failure. Thread inserts are the usual repair.
An engine that’s been looked after can still run a long time, but check oil consumption carefully before buying.
3VZ-E (3.0L V6)
Found in: Toyota pickups and the 4Runner, from the late 1980s to the mid-1990s.
The 3VZ-E is known for premature head gasket failure and overheating, and it isn’t very powerful for its era. Toyota ran a head gasket recall on some of these trucks. Many have since been repaired, so an older engine with documented head gasket work can be fine. One that’s still on its original gaskets is a gamble.
7M-GE and 7M-GTE (3.0L Inline-Six)
Found in: the Mk3 Supra and Cressida, in the mid-1980s to early 1990s.
These engines have a long-standing reputation for blown head gaskets, commonly blamed on head bolt torque specifications that were too low from the factory. Owners typically fix the problem with upgraded head studs and a quality gasket. A 7M with that work done can be a solid engine. One without it is a risk, especially the turbocharged 7M-GTE.
Early 1ZZ-FE (1.8L Four-Cylinder)
Found in: the Corolla, Matrix, Celica, MR2 Spyder and others, from the late 1990s.
Early engines, roughly up to the 2002 model year, are widely reported to burn oil, a problem usually blamed on the piston ring and oil-control design. Toyota revised the design, and later 1ZZ-FE engines are generally considered sound.
1MZ-FE and Other Oil-Gelation-Era Engines
Found in: the 1997–2002 Camry, Avalon, Sienna, Solara, Highlander and Lexus ES/RX, among others (3.0L V6), plus some four-cylinder models.
Toyota acknowledged an engine oil gelation (“sludge”) problem on a range of late-1990s to early-2000s models and set up a special policy to cover repairs. Sludge was most common in engines with long oil change intervals or lots of short trips. Today, any 1MZ-FE that has had regular oil changes is usually a decent engine. Just check under the oil filler cap for heavy deposits.
Early V35A-FTS (3.4L Twin-Turbo V6)
Found in: the 2022-and-later Tundra and Sequoia, Lexus LX 600 and LS 500.
In 2024, Toyota recalled certain 2022–2023 Tundra and Lexus LX models because machining debris left during manufacturing could damage the main bearings and lead to engine failure. The remedy was engine replacement. If you’re shopping for an early V35A truck, check that its recall work is done and look for any later campaigns that apply to its VIN.
Engines That Need Care, but Aren’t “Avoid” Engines
A few other Toyota engines have well-known issues that are manageable when you know about them:
- 2GR-FE 3.5L V6 (early versions). Many mid-to-late 2000s engines used a rubber VVT-i oil feed line that could burst and dump oil quickly. Toyota replaced it with an all-metal line under a service campaign. On an older 2GR, check which line is fitted. Otherwise, this is one of Toyota’s best engines.
- 4GR-FSE 2.5L V6. Used in some Lexus IS models, this direct-injection-only engine can build up intake valve carbon.
- 1GR-FE 4.0L V6. Generally durable, but some engines develop head gasket leaks at high mileage.
Summary Table
| Engine | Typical years | Main problem | Toyota response |
|---|---|---|---|
| 2AZ-FE 2.4L I4 | Early 2000s–early 2010s | Oil burning, head bolt threads | Oil consumption warranty enhancement on some models |
| 3VZ-E 3.0L V6 | Late 1980s–mid 1990s | Head gaskets, overheating | Head gasket recall on some trucks |
| 7M-GE/GTE 3.0L I6 | Mid 1980s–early 1990s | Head gaskets | Fixed by owners with head studs |
| 1ZZ-FE 1.8L I4 (early) | Late 1990s–about 2002 | Oil consumption | Design revised |
| 1MZ-FE 3.0L V6 and others | 1997–2002 models | Oil sludge | Special policy |
| V35A-FTS 3.4L TT V6 (early) | 2022–2023 recall population | Machining debris, bearings | Engine replacement recall |
Toyota Engines With the Best Records
For balance, many Toyota engines have excellent reputations: the 22R/22RE four-cylinder, the 1UZ-FE V8, the 2JZ inline-six, the 2GR-FE V6 (with the metal oil line), the UR-series V8s and the 1FZ-FE inline-six. Several make our list of the top 10 most reliable engines ever made.
How to Check a Used Toyota Engine
- Run the VIN through your national recall database and ask a Toyota dealer about open campaigns or past special-policy work.
- Check oil consumption. On 2AZ-FE and early 1ZZ-FE engines, a low dipstick between changes is a red flag. A blue puff at startup is another.
- Look for coolant loss or oil in the coolant, signs of head gasket or head bolt problems.
- Remove the oil filler cap and look for thick, tarry sludge on engines from the gelation era.
- Ask for service records. Regular oil changes do more for these engines than anything else.
For a wider look at how other brands’ problem engines compare, see the least reliable engines of all time.