Most common problems with diesel cars
A diesel’s core engine is usually tough. Most problems come from the systems around it and from how the engine is used. The most common trouble spots are:
- Fuel contamination, especially water.
- Injector and high-pressure pump failures.
- Emissions equipment: EGR valves and coolers, diesel particulate filters (DPFs) and sensors.
- DEF and SCR faults on newer vehicles.
- Oil dilution from fuel getting into the engine oil.
- Hard starting, often from batteries, glow plugs or air in the fuel.
- Turbocharger problems, including oil leaks and sticking variable vanes.
- Overheating and head gasket failure, less common but expensive.
Diesel cars that mostly do short trips are particularly prone to DPF, EGR and oil dilution problems, because the engine and exhaust rarely get hot enough to clean themselves. For how all these parts fit together, see how diesel engines work.
Fuel contamination and water
Water is one of the worst things that can get into a diesel fuel system. It causes corrosion inside pumps and injectors, reduces lubrication, and can support microbial growth (“diesel bug”) in the tank, which clogs filters. Dirt and debris cause wear in the tightly toleranced parts of modern injection systems.
Most diesels have a water separator, often combined with the fuel filter, and many have a water-in-fuel warning light. To reduce the risk:
- Change fuel filters on schedule and drain the separator if your vehicle needs it.
- Buy from busy stations where fuel turns over quickly.
- Don’t let a vehicle or machine sit for long periods with a half-empty tank, which allows condensation.
- Treat a water-in-fuel warning promptly.
Injector and high-pressure pump failures
Modern injection systems run at very high pressures and tight tolerances, so they’re less forgiving than older mechanical systems. Common symptoms of injector problems include rough idle, misfire, knocking, more smoke and higher fuel consumption. A failing high-pressure pump can cause hard starting, power loss and rail pressure fault codes, and in a bad failure it can shed metal particles through the whole system.
Causes include contaminated fuel, wear, poor filtration and running on the wrong fuel. Our common rail diesel injection guide explains how the system works and why it’s sensitive.
Emissions system problems
EGR valve and cooler clogging
The exhaust gas recirculation (EGR) system sends some exhaust back into the intake to reduce nitrogen oxides. Diesel exhaust carries soot, and mixed with oily crankcase vapour it can form thick carbon deposits that stick EGR valves and block intake passages. EGR coolers, which use engine coolant to cool the exhaust, can also clog or crack. A cracked cooler can leak coolant into the intake and cause white smoke and coolant loss.
DPF blockage
The diesel particulate filter traps soot and burns it off in a process called regeneration. When regenerations can’t complete, usually because of short trips, interrupted regens or an upstream fault, the filter clogs. Warning lights, power loss and limp mode follow. This is covered in detail in how DPF regeneration works and why it fails.
Sensor failures
Modern diesels rely on exhaust temperature sensors, differential pressure sensors across the DPF, NOx sensors, and more. These live in a harsh, hot environment and fail relatively often. A single failed sensor can trigger warning lights, block regeneration or put the vehicle into reduced power.
The DEF system: how it works and what goes wrong
How the DEF system works
Diesel exhaust fluid (DEF), sold as AdBlue in many countries, is a solution of about 32.5 percent high-purity urea and 67.5 percent deionised water, made to the ISO 22241 standard. It’s part of the selective catalytic reduction (SCR) system that reduces nitrogen oxides (NOx).
Does DEF run through the engine? No. DEF has its own tank, usually with a blue filler cap, and never mixes with fuel or passes through the cylinders. A pump sends it to a dosing injector in the exhaust, upstream of the SCR catalyst. In the hot exhaust, the urea breaks down to ammonia, and the catalyst uses it to convert NOx into nitrogen and water vapour.
The main components are:
- DEF tank, with level and quality sensors and a heater.
- Pump or supply module.
- Lines, often heated.
- Dosing injector in the exhaust.
- SCR catalyst.
- NOx sensors before and after the catalyst, which let the computer check the system is working.
Common DEF faults
- Crystallisation: DEF that dries out leaves white urea crystals that can clog the dosing injector, lines or pump.
- Freezing: DEF freezes at about 12°F (−11°C). Systems have heaters, and freezing usually doesn’t damage a properly designed system, but heater failures cause fault codes in winter.
- Contaminated or degraded fluid: DEF breaks down faster when stored hot, and dirt or other fluids in the tank can damage the system.
- Sensor, heater and pump failures, including NOx sensor failures.
- Low or empty tank: most vehicles warn you well in advance, then limit speed or power, and some will not restart once the tank is empty until it’s refilled.
What DEF costs and how much you use
Price depends on where you buy it. DEF is usually cheapest per gallon from pumps at truck stops and most expensive in small containers from dealers. Consumption is a small fraction of fuel use; it’s commonly quoted at a few percent of diesel consumption, so a light-duty vehicle may go thousands of miles between top-ups. Your owner’s manual or dashboard will show the expected range.
Can you use urine for DEF?
No. Urine does contain urea, but at a much lower and variable concentration, along with salts, minerals and other substances. DEF has to meet a tight purity standard because contaminants can poison the SCR catalyst and damage the pump and injector. The quality sensor in many systems will also detect it and trigger faults. Using anything other than certified DEF risks a costly repair.
What DEF repairs cost
Costs vary widely by vehicle. A sensor or heater replacement is at the lower end; a complete DEF tank and pump module, a dosing injector, or an SCR catalyst can run into the thousands. If you’ve put the wrong fluid in the DEF tank, the system typically needs draining and flushing, and contaminated parts may need replacement. Get a diagnosis and a written estimate before authorising work.
Putting DEF in the diesel tank
This is a serious mistake. DEF in the fuel system can crystallise and corrode pumps and injectors. Don’t start the engine, and have the vehicle towed to a workshop for the fuel system to be drained and inspected.
Are DEF deletes legal?
Removing, disabling or bypassing DEF/SCR or other emissions equipment on a road vehicle is generally illegal in the United States under the Clean Air Act, and similar rules apply in many other countries. Regulators have taken enforcement action against both sellers of “delete” parts and businesses that install them. The US EPA has in recent years moved to reduce how severely engines derate when a DEF fault occurs, but that is about how the system behaves when it fails, not permission to remove it. Rules can change, so check current law where you live, but don’t assume a delete is legal.
Oil dilution
Fuel can get into the engine oil in several ways: a leaking injector, extended idling, frequent short trips, and on some engines the late “post-injection” used to heat the exhaust for DPF regeneration, which can wash fuel past the rings. Diluted oil is thinner, protects bearings less well and can raise the oil level on the dipstick. An oil analysis will show the percentage of fuel. If you notice the oil level rising between changes, have it checked.
Hard starting, smoke and overheating
- Hard starting usually comes down to batteries, glow plugs, air in the fuel or fuel supply problems. See how diesel engines start.
- Smoke is a useful diagnostic clue. Black, white and blue smoke point to different causes; see what diesel smoke colours mean.
- Overheating can come from coolant leaks, a failed thermostat or water pump, a blocked radiator or intercooler stack, or internal leaks from a head gasket or EGR cooler.
Head gasket and other mechanical failures
Most diesels have robust head sealing, but head gasket failures do happen, particularly on some designs and on engines tuned well beyond factory output. Signs include coolant loss, pressurised coolant hoses, white exhaust smoke and overheating.
Worn rings and cylinder glazing cause blow-by, where combustion gas leaks into the crankcase. See how to tell if a diesel has blow-by.
Diesel runaway: causes, damage and how to stop one
A runaway happens when a diesel starts burning a fuel source the engine can’t control, so it keeps accelerating even with the key off and the accelerator released. Because a diesel doesn’t need a spark, cutting the ignition doesn’t stop it.
What causes a runaway
- Engine oil entering the intake, most often from a failed turbocharger seal or an overfilled crankcase pushing oil through the breather.
- Flammable vapours in the surrounding air, for example near gas leaks at oil and gas sites, or in a fuel spill.
- A stuck injection pump or governor on older mechanical engines, holding the fuel control open.
- Severe blow-by forcing oil mist through a crankcase ventilation system that feeds into the intake.
What damage a runaway can do
A runaway engine can quickly exceed its safe speed. Possible results include valves floating and hitting pistons, bent connecting rods, spun bearings, a destroyed turbocharger, and in the worst cases, the engine breaking apart. Even if it’s stopped in time, the engine should be inspected before it’s run again. There’s also a fire risk, and nearby people can be injured by parts or hot oil.
How to handle a diesel runaway
Safety comes first. If you can’t stop it safely, move yourself and others well away.
The general principle is to cut off the air or the fuel source:
- On a manual-transmission vehicle, some drivers stop a runaway by putting it in a high gear with the brakes firmly applied and releasing the clutch to stall it. This is only an option if it’s safe to do.
- Starve the engine of air. On equipment with an emergency air shut-off valve, operate it. Otherwise, a CO₂ fire extinguisher discharged into the air intake can displace oxygen. Covering the intake with a flat, rigid object is another method used, but the suction is very strong; never use your hand, a rag or anything that can be sucked in.
- Don’t open the engine bay or remove intake ducting while it’s running unless you’ve been trained to do it; you risk serious injury.
Industrial equipment working in hazardous areas is often fitted with automatic air intake shut-off valves for exactly this reason.
Which diesel engines to be wary of
It’s not fair to name a single “worst” diesel, because reputations depend on the model year, how an engine was used and what fixes were applied. Some engines are well known for specific weaknesses; for example, the Ford/Navistar 6.0-litre Power Stroke is often cited for head gasket and EGR cooler issues. When buying used:
- Research the specific engine and model year, including known issues and recalls.
- Look for complete service records, particularly oil and fuel filter changes.
- Be cautious with vehicles that show signs of emissions equipment removal or heavy tuning.
- Consider your driving: a modern diesel used mostly for short trips may be a poor choice regardless of brand.
For lifespan expectations, see how long a diesel car engine will last.
Wrong-fuel accidents
Putting gasoline in a diesel is covered in detail in what happens if you put gasoline in a diesel engine. The reverse, putting diesel in a gasoline car, is usually less damaging to the fuel pump but makes the engine run badly or not at all, smoke heavily and can foul spark plugs and catalytic converters. Repair often involves draining the tank, flushing the fuel system and replacing filters, which tends to cost less than major diesel fuel-system repairs, though prices vary with the vehicle and how far it was driven.
Is diesel fuel toxic?
Yes, diesel fuel is harmful. Swallowing it, breathing its vapour or mist, or prolonged skin contact can cause health effects, and diesel exhaust is classified as a cause of cancer by the International Agency for Research on Cancer. Avoid siphoning by mouth, wear gloves when handling fuel, and seek medical advice if someone swallows diesel or has a significant exposure. High-pressure fuel leaks can also inject fuel through the skin, which needs urgent medical attention.
Preventing most diesel problems
- Keep up with oil, fuel filter and air filter changes.
- Use the correct oil specification for engines with a DPF.
- Buy fuel and DEF from reputable sources, and keep DEF containers sealed and out of the heat.
- Give the engine regular longer drives at steady speed so it and the DPF get properly hot.
- Avoid long periods of idling; see why you shouldn’t let diesels idle.
- Act on warning lights rather than driving on them.