Engine Problems

What are the most common carburetor problems?

The most common carburetor problems, including clogged jets, flooding, air leaks, choke and accelerator pump faults, with the symptoms each causes and how to fix them.

On this page
  1. How a carburetor works (briefly)
  2. The most common carburetor problems
  3. Symptoms and likely carburetor causes
  4. Clean, rebuild or replace?
  5. How to prevent carburetor problems

Short answer: the most common carburetor problems are:

  1. Clogged jets and passages, usually from stale fuel leaving varnish. This is by far the most frequent.
  2. Flooding or leaking from a stuck float or worn needle valve
  3. Air leaks at gaskets or throttle shafts, which make the engine run lean
  4. Choke faults
  5. A failed accelerator pump on carburetors that have one
  6. Incorrect mixture or idle adjustment

These cause most no-starts, rough idles, surging and hesitation in carbureted engines.

How a carburetor works (briefly)

A carburetor mixes fuel with incoming air using pressure differences.

  • The float bowl. Fuel enters a small bowl, where a float and needle valve keep it at a set level, much like the valve in a toilet tank.
  • The venturi. Air rushing through a narrowed section, the venturi, creates low pressure that draws fuel from the bowl through precisely sized jets.
  • The circuits. Different circuits handle different conditions. The idle (or pilot) circuit handles idle and low throttle. The main circuit handles higher throttle. Many carburetors add an accelerator pump to squirt extra fuel when the throttle opens quickly, and a choke that richens the mixture for cold starts.

Because the passages and jets are so small, even a thin film of deposits can upset the mixture.

The most common carburetor problems

Clogged jets and passages

When gasoline sits for weeks or months, its lighter parts evaporate and the rest can turn into gum and varnish. Ethanol-blended fuel can also absorb water and contribute to corrosion. Deposits then partly or fully block the jets and small passages.

Symptoms:

  • Hard starting or no start
  • An engine that only runs with the choke on
  • Surging at idle
  • Stalling when the throttle opens
  • Power loss at higher speeds

Fix: disassemble and clean the carburetor thoroughly with carburetor cleaner. Clear each passage with compressed air, and replace gaskets as needed. Avoid enlarging jets by scraping them with wire that’s too hard or too thick.

Flooding and leaking

If the float sticks, the float is set too high, the float itself has a leak, or the needle valve and seat are worn or dirty, fuel keeps flowing into the bowl. It then overflows into the engine or out of the carburetor.

Symptoms:

  • Fuel dripping from the carburetor or air box
  • A strong gasoline smell
  • Black smoke and fouled spark plugs
  • Hard starting from flooding
  • Fuel in the engine oil, which can thin it and cause damage over time

Fix:

  • Clean or replace the needle and seat
  • Free or replace the float
  • Set the float level to specification

Many engines have a fuel shutoff valve. Closing it during storage helps limit damage from a leaking needle.

Air leaks

Air that enters downstream of the carburetor isn’t metered, so the mixture runs lean. Common leak points:

  • The carburetor-to-intake gasket
  • Cracked rubber intake boots, common on motorcycles
  • Loose mounting bolts
  • Worn throttle shaft bushings
  • Leaking vacuum fittings

Symptoms:

  • High or surging idle
  • Hesitation
  • Backfiring through the exhaust or intake
  • Sometimes a hiss or “chirp”

Fix: replace gaskets and boots, tighten fasteners, and repair or replace worn throttle shafts. A careful spray test can help locate leaks: brief bursts of a suitable spray around joints while the engine idles, watching for an idle change. Be careful with flammable sprays near hot parts and ignition sources.

Choke problems

  • A choke stuck closed makes the engine run too rich: black smoke, fouled plugs and poor running once warm.
  • A choke that won’t close makes cold starts difficult.
  • Automatic chokes, found on many older cars, use a thermostatic spring and sometimes an electric heater. They can stick, lose adjustment or have a failed heater. The linkage may need cleaning or adjustment.

Accelerator pump failure

Many car and some motorcycle carburetors use a small pump to add fuel when the throttle opens suddenly. When its diaphragm or cup dries out or tears, the engine hesitates, stumbles or backfires on quick throttle openings, even if it idles and cruises fine. You can often see the pump squirt. With the engine off and the air cleaner removed, open the throttle quickly. Keep clear of flames and sparks, because this releases raw fuel.

Incorrect adjustment

Idle speed and idle mixture screws, and on some carburetors high-speed mixture screws, set how the engine runs. Mis-set screws cause rough idle, stalling, poor economy or excessive smoke. Many modern small engine carburetors have fixed or limited adjustments for emissions reasons. If yours has adjustable screws, follow the manufacturer’s starting settings and procedure.

Worn throttle shaft and parts

On older or high-hour carburetors, the throttle shaft can wear its bore. That creates an air leak and an unstable idle that cleaning won’t fix. Linkages, springs and mounting flanges can also wear or warp.

Torn diaphragms

Diaphragm-type carburetors are common on chainsaws, string trimmers and other tools that run at any angle. Constant-velocity motorcycle carburetors also use diaphragms. Diaphragms can stiffen, swell or tear. Symptoms include no start, poor acceleration or an engine that won’t run at full throttle. Rebuild kits usually include new diaphragms.

Carburetor icing

In cool, humid conditions, evaporating fuel can chill the carburetor enough for ice to form in the venturi or around the throttle plate. This causes rough running or stalling that clears once things warm up. It’s a known issue in some engines, especially in aviation, where carburetor heat systems exist for this reason. Some cars and small engines have intake heating to reduce it.

Symptoms and likely carburetor causes

Symptom Likely carburetor cause
Won’t start after storage Varnished jets, stuck float, dried diaphragm
Only runs on choke Clogged main jet or passages, air leak, low float level
Surging at idle Lean mixture: partly blocked idle circuit or air leak
Fuel leaking, strong fuel smell Stuck float, worn needle and seat, leaking float
Black smoke, fouled plugs Choke stuck closed, flooding, rich mixture setting
Stumble on quick throttle Accelerator pump failure, lean transition circuit
Rough idle that cleaning didn’t fix Worn throttle shaft, vacuum leak, mis-set mixture
Dies on hot days or after warming Vapor-related fuel issues, float level, vent problems
Rough running in cool, damp weather Carburetor icing

Not every symptom in this table is caused by the carburetor. Ignition problems and low compression can look similar. The step-by-step checks in common small engine problems and how to diagnose engine problems help rule them out.

Clean, rebuild or replace?

  • Clean when the problem is fresh varnish or debris and the parts are in good condition.
  • Rebuild with a kit (gaskets, needle and seat, sometimes jets and diaphragms) when gaskets have hardened, the needle is worn or the carburetor has been apart before.
  • Replace when the body is corroded, the throttle shaft is badly worn, threads are stripped, or a rebuild costs more than a new carburetor. That’s common for small engine carburetors. Make sure the replacement matches your engine model.

After any carburetor work, check for fuel leaks before running the engine.

How to prevent carburetor problems

  • Don’t let fuel sit for long periods. Use a stabilizer, or drain or run the carburetor dry before storage, as the manufacturer recommends.
  • Use fresh fuel, and ethanol-free fuel where it’s recommended and available.
  • Keep the air filter clean so dirt doesn’t reach the jets.
  • Fit an inline fuel filter if the engine design allows it.
  • Close the fuel shutoff valve during transport and storage if there is one.

The complete guide to engine problems

How to Diagnose Engine Problems: Symptoms, Causes and Fixes
Read the guide

Keep exploring

Guides from other topics

All topics →